Hyperx Fury 8GB DDR4-2666 CL16 Black

HX426C16FB2/8
8GB 1G x 64-Bit
DDR4-2666 CL16 288-Pin DIMM
DESCRIPTION
HyperX HX426C16FB2/8 is a 1G x 64-bit (8GB) DDR4-2666 CL16 SDRAM (Synchronous DRAM) 1Rx8, memory module, based on eight 1G x 8-bit FBGA components per module. Each module supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0. Each module has been tested to run at DDR4-2666 at a low latency timing of 16-18-18 at 1.2V. Additional timing parameters are shown in the Plug-N-Play (PnP) Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows:
Note: The PnP feature offers a range of speed and timing options to support the widest variety of processors and chipsets. Your maximum speed will be determined by your BIOS.
JEDEC/XMP TIMING PARAMETERS
JEDEC/PnP: DDR4-2666 CL16-18-18 @1.2V
XMP Profile #1: DDR4-2666 CL16-18-18 @1.2V
SPECIFICATIONS
CL(IDD) : 16 cycles
Row Cycle Time (tRCmin) : 45.75ns(min.)
Refresh to Active/Refresh Command Time (tRFCmin) : 350ns(min.)
Row Active Time (tRASmin) : 29.25ns(min.)
Maximum Operating Power : TBD W
UL Rating : 94 V – 0
Operating Temperature : 0C to +85C
Storage Temperature : -55C to +100C
FEATURES
Power Supply: VDD = 1.2V Typical
VDDQ = 1.2V Typical
VPP = 2.5V Typical
VDDSPD = 2.2V to 3.6V
Nominal and dynamic on-die termination (ODT) for data, strobe, and mask signals
Low-power auto self refresh (LPASR)
Data bus inversion (DBI) for data bus
On-die VREFDQ generation and calibration
Single-rank
On-board I2 serial presence-detect (SPD) EEPROM
16 internal banks; 4 groups of 4 banks each
Fixed burst chop (BC) of 4 and burst length (BL) of 8 via the mode register set (MRS)
Selectable BC4 or BL8 on-the-fly (OTF)
Fly-by topology
Terminated control command and address bus
Height 1.340” (34.04mm), w/heatsink

What’s in the box
1 x Kingston 8GB DDR4 2666MHz Desktop Memory Module (HX426C16FB2/8)