Tork Craft 800W Rotary Hammer Drill

TorkCraft – Rotary Hammer 800W

Application:
– Drilling into various masonry materials using various masonry drill bits.
– Chiselling various masonry materials using various chiselling points.

Full Specification:

Packaging Dimensions: 402(L) x 292(H) x 115mm(T)
Packaging Weight: 5.25 kg
Tool Dimensions: 350 x 205 x 82mm
Weight of the Tool: 3 kg
Material: Body and handle: Plastic
Finish: Grey plastic with red and black accents

Content:
Auxiliary handle
Depth Rod
Flat chisel
Point chisel
Ø 8mm SDS drill bit
Ø 10mm SDS drill bit
Ø 12mm SDS drill bit

Technical Specifications:
Max RPM: 0-1200 RPM
Chuck type: SDS PLUS
Wattage: 800W
Impact energy: 2.8 J
Drilling Capacity: Wood – 30mm, Steel – 13mm, Concrete – 26mm
Max Impact rate: 0- 5500 IPM
Motor: Brushed
Voltage: 230V

Additional info:

Installing chisel bits and drill bits:
For assembly, pull back the fastening sleeve and hold. Push and rotate the dust-free accessory into the tool holder as far as it will go. The tool will lock automatically. Check that it has locked by pulling the tool.
To remove the SDS accessory, pull back the fastening sleeve and remove the accessory.
Depth guide

Insert the required drill bit. Fit the depth stop into the hole of the auxiliary handle and set the required depth.
Rotation setting

R-BOTTOM (Forward) = To select reverse rotation, push the lever down on the top side of the handle.
L-TOP (Reverse) = to select forward rotation, release the on/off switch and push the lever up on the top side of the handle.
Fitting the auxiliary handle

Loosen the auxiliary handle by unscrewing it. Slide the auxiliary handle clamp over the collar behind the bit holder. Rotate the side handle to the desired position and tighten the handle.

What’s in the box
1 x Rotary Hammer Drill.
1 x Auxiliary handle
1 x Depth Rod
1 x Flat chisel
1 x Point chisel
1 x Ø 8mm SDS drill bit
1 x Ø 10mm SDS drill bit
1 x Ø 12mm SDS drill bit