ECONOFIRE 130mm External (Rear) Flue Kit

This flue kit allows you to install your fireplace at 4.7m with the flue exiting straight out the rear of the fireplace, through the outer wall and connected to a T-piece and a single /double skin convertor allowing the double skin pipe to then travel vertically alongside the outer wall toward and above the roof line. (the kit excludes the roof flashing component which needs to be purchased separately depending on the roof covering)
Single skin flue pipes get hot and can serve as an extension of the fireplace by helping to heat your space, whereas the double skin flue pipe is made up of two plain flue pipes within each other with an insulation material of 25mm.
A double skin flue pipe will also decrease the build-up of condensation within your flue, as the insulation prevents the hot air from cooling down too quickly. It is therefore preferable and safer to use insulated flues once the flue pipe leaves the interior of the room that is being heated.
All our flues and fittings are 0.4mm 304-grade stainless steel and are seam welded and utilize a clamping method of assembly.
All single skin stainless-steel flues discolour over time, due to a natural chemical reaction caused by exposure to oxygen in the air and the heat from your fireplace. Expect the colour range from golden to amber, even purples, and blues, depending on how hot your fireplace is fired.

What’s in the box
1 x 130mm Single Skin Pipe 0.5m
2 x 130mm Single Skin Closure Plates
1 x 130mm Single Skin T-Piece with Cap
1 x 130mm Single Skin to Double Skin Converter
3 x 130mm Double Skin Pipes 1m
2 x 130mm Double Skin Wall Brackets
4 x 130mm Single Skin Clamps
4 x 130mm Double Skin Clamps
1 x 130mm Double Skin Drum-Hat Cowl
1 x Installation Guide / Manual