10-Sheet Mosaic Tiles Peel and Stick Backsplash Kitchen (Mint green)

Easy install
Do it yourself – Enjoy the fun
Just peel, interlock and stick
Easy to cut with sharp utility knife
No Grout/ No Mess up /Save your money

Specifications
Material: Vinyl
Unit size: 30.5×30.5cm
Thickness: About 1.2 mm
Unit weight: 80g / Sheet

Premium Peel and Stick Backsplash: Wall tiles are made of eco-friendly material, resistant to heat and moisture, easy wipe to remove the stains.
Approach Ceramic Tile: High-quality 3D gel tiles, not just a sticker tile, Perfectly decorated in Kitchen island walls, laundry room, RV, washbasin, bedroom walls and bathroom backsplash etc.

Purchase Enough Tiles at A Time
Please consider 3-5% cutting loss and purchase enough tiles at a time to make sure they come from the same batch to avoid slight colour difference.

Recommended Surface
smooth ceramic tiles backsplash, smooth glass tiles backsplash, acrylic wall panel, pained gypsum, wall linoleum, stainless metal, mirror, laminate, wallpaper (if some corners are peeling, just peel them off and install tiles over them).

Non-Recommended Surface
oily wall, brick wall, stucco wall, stone wall, unfinished wall (gypsum or plaster), unpainted plywood, Wet wall

Wall & Tile Temperature
The temperature of the wall and tiles should be at least about 21 for 12 hours before installation and 24 hours after installation. This is very important because if wall and tiles are cold, the tiles will not stick well. During the winter, the wall temperature is usually lower than room temperature so make sure that your walls are warm.

Press All Grout Lines Firmly
Make sure you press ALL grout lines firmly, and try NOT to touch the adhesive side as much as you can.

Use Extra Spray Adhesive or Super Glue
The tile need to be installed over clean and sleek surface. Please note that rough surfaces such as porous wood, embossed ceramic tiles or textured wallpaper are not suitable to install; NOT all the latex/repainted walls can be installed directly, for latex or repainted wall, the 3M Spray Adhesive is recommended.

Installation guide:
– Tools needed: scissors, carpet knife (excluded)
– Before cutting, please measure the detailed dimensions of the wall
– Clean the surface to dust-free before apply
– Cut to the appropriate size according to the decorative area
– Peel off the back sheet and stick it on a flat surface
– Press down on the panel to make sure it is properly connected to the wall

Note:
– Due to different lighting and screen settings, the color of the item may differ slightly from the picture
– Manual measurement, please allow slight difference in dimensions

What’s in the box
10 Sheets