MAC AFRIC 1/2″ IN Drive 65 – 335 NM Torque Wrench

Torque wrench tightening sequence

When you’re torque-tightening a couple of bolts on flanges or surfaces, you want to evenly unfold the load throughout the bolts at some point of the process.
Point Load

The factor load is the quantity of load in a unique spot in the structure, as antagonistic to a uniform load, which is unfold evenly for the duration of the structure. Since we usually tighten bolts one at a time, you prefer to be sure that the bolts will all elevate an even load. Otherwise, a factor load can reason structural failure.
Torque Pattern and Load Scattering

Torque sample is the applicable tightening sequence so the bolts are top stretched and can evenly elevate the load.

Whether there are 4 bolts or 12, torque sample lets in you to scatter the load. Instead of tightening bolts clockwise – which would put greater load on one facet – torque sample usually dictates that you tighten bolts on contrary facets of the flanges.

It’s extra than simply the sequence that you tighten in though. You ought to additionally sample the quantity of torque at some point of the sequences, gradually growing it in every round. For instance, in a four-bolt pattern, you would follow one-third the last torque to every bolt, then two-thirds on the 2nd spherical and sooner or later full torque on the 0.33 round. If we have been to observe the full torque in the first round, then bolt one would have too a great deal factor load regardless of the following sequence.
Breakout Torque

The contrary of torque tightening is breakout – or breakaway – torque. This is the torque required to loosen bolts and is lots higher, normally at least twice as excessive due to corrosion and viable expansion.