Filter

Mecer 2400VA (1440W) Inverter Battery Charger (UPS)

K7,542.23

Category: Uninterrupted Power Supply (UPS)

Description
Reviews (0)

Mecer 2400VA, 1400W, 24V DC-AC Inverter (Modified Sine Wave)

LCD Display

Please note that this unit will not turn on if not connected to at least two 12V batteries connected in series for 24V.

The fan will turn off once the batteries are fully charged!

Cables to connect the unit to a battery are included.

A 220V power cable is included to recharge the battery while the power is on.

May be used as an inverter (to power 220V devices such as TVs from a battery) or a UPS (runs the device from the standard 220V power while the battery charges)

*EXTERNAL BATTERIES REQUIRED*

MODEL: Mecer IVR-2400LBK

CAPACITY: 2.4KVA/ 1440W

Power Factor: 0.6

Intput voltage range: 90-280VAC

LINE MODE

Output voltage: Bypass mode: 0utput voltage same as input voltage AVR mode:Output voltage = Input voltage*1.2 @ Input voltage<200VAC

Output Frequency: Same as input

BATTERY MODE

Output voltage: 230Vac 10%

Transfer Time: 20ms typical

Waveform: Modified Sine-wave

OVERLOAD CAPABILITY

Bypass Mode (in VA and Watts): Load >110%15% , alarm 5 mins then fault Load >130% 15%, fault immediately.

AVR Mode (in VA and Watts)@ Input voltage > 170VAC: Load >100%15%, go to bypass mode

AVR Mode(in VA and Watts)@ Input voltage 60%15%, go to bypass mode

Battery Mode (in W): 1) Load>110% 15%, overload alarm for 15s, and then will switch to fault mode for 10s, Then unit will re-start 5 times. 2) Load>120% 15% , fault & cut off O/P immediately.

SHORT CIRCUIT PROTECTION

Line Mode: Breaker

Battery Mode: Current limit +Firmware Protection

BATTERY

Battery Voltage: 24VDC

Acceptable Battery Type: Rechargeable lead-acid battery, Deep discharge battery

Polarity Reserve Protection: Yes

Charger available I/P range: 90~280V

CHARGER

Constant Current Charger Voltage:28.6VDC 2%

Floating Charge Voltage: 27.4VDC 2%

Maximum Charge Current: 10A or 20A