Showing 85–96 of 292 results
Manufactured from hardened and tempered ground steel. Graduated to 2mm on one side and 18inch and 116inch increments on the other. In hands of a skilled carpenter the simple rafters square becomes an indispensable calculating device of immense capacity. Enabling the carpenter to easily determine the length of any common hip valley or jack rafter…
Cranked handle assists with location of Wrench on to fixings within a recess. What’s in the box 1 x Kennedy 30Mm Ring Cranked Podger Wrench
Cranked handle assists with location of Wrench on to fixings within a recess. What’s in the box 1 x Kennedy 24Mm Ring Cranked Podger Wrench
Manufactured from forged and hardened steel with machined drive faces to ensure good contact with the fastener. With flat striking faces to allow hammer blows to be used to loosen or tighten stubborn fasteners. Manufactured to DIN 7444. What’s in the box 1 x Kennedy 1.7/8″ A/F Ring Slogging wrench
“Double-Ended Made from chrome vanadium steel with a black oxidised finish. Conform to DIN 895.” What’s in the box 1 x Kennedy 36Mmx41Mm Black Open End Wrench
Replaceable hard nylon face with thread. All purpose face suitable light and heavy duty applications. To suit nylon faced hammers and safeblow hammers. What’s in the box 1 x Kennedy 44Mm Dia Replacement Nylon Face
Replaceable hard nylon face with thread. All purpose face suitable light and heavy duty applications. To suit nylon faced hammers and safeblow hammers. What’s in the box 1 x Kennedy 38Mm Dia Replacement Nylon Face
Replaceable hard nylon face with thread. All purpose face suitable light and heavy duty applications. To suit nylon faced hammers and safeblow hammers. What’s in the box 1 x Kennedy 32Mm Dia Replacement Nylon Face
Made from impact resistant transparent polypropylene allowing stored parts to be viewed when the drawer is closed. The lip on the rear of the drawer allows it to be opened fully without falling out. Drawers can be partitioned to allow further product separation to suit specific storage requirements see 593 970 for small drawers or…
Leather made with five pockets two loops webbing belt and tape holder. What’s in the box 1 X Kennedy 5 Pocket 2 Loop Tool Nail Pouch
Manufactured from natural split leather with four medium and one large leather tool loops. Rivetted metal tool clip with metal T bar and chain. Six slits for attaching to belt. Fully riveted construction. Belt not included. What’s in the box 1 X Kennedy Tan Leather 5 Loop Tool Holster
7 Piece Standard Length Standard Length No.6 x 75 No.8 x 85 No.10 x 85 No.10A x 100 No.12 x 100 No.16 x 120 No.20 x 120mm. 7 Piece Standard ?Medium Length Standard Length No.10 x 85 No.12 x 100 No.14 x 100 No.16 x 120 No.20 x 120. Medium Length No.24 x 150 No.26…
End of content
End of content
No products in the cart.
